USG Bu-353 MOUSE RECEIVER
GPS Navigation for your laptop
High performance GPS providing great accuracy for your global positioning needs.
Transform your laptop into a navigation system with a GPS receiver. Plug the GPS receiver into your notebook’s USB port and you’re ready to plan trips, locate destinations and find points of interest such as hotels and restaurants. Your navigational solution operates using your notebook’s power source and provides precise information on your location and how to get to your destination.
This USB GPS for Laptop is a low power consumption GPS device. Simply plug into the USB port of a PC or laptop and you’re ready to start. Power is derived from the USB bus so only a single cable is required. The GPS Receiver is designed to plug into most any laptop PC’s USB port without the need of an additional source for power! Forget dealing with extra batteries, keyboard pass-through cables or 12VDC cigarette lighter adapters, because power and data are both transmitted through a single cable connected to the USB port. Comes with a 59″ Cable.
Travel positions are updated in real-time on your laptop or tablet PC with use of your own street mapping software.
This USB GPS for Laptop can be used with virtually any mapping software. Use it in your car, boat or RV; this GPS for Laptop can be used anywhere in world.
Available with iGuidance mapping software.
USB Connection
Details
Status: In Stock
Tech Specs
Compatible with mapping software like:
• Fugawi
• Microsoft Streets and Trips
• National Geographic TOPO!
• iGuidance
• and most other software that support NMEA data protocol
GPS MOUSE PACKAGE
FEATURES
• 2nd generation low-power consumption GPS receiver
• Fast acquisition and reacquisition times
• Easy LED indicator for GPS status
• Supports sleeping mode
• Plug and Play function
• Slim case design
• All-in-view 20-channel parallel processing
• Built-in patch antenna
• Very High sensitivity to satellite signal (Tracking Sensitivity:-159 dBm)
• Build-in SuperCap to for rapid satellite acquisition
• Extremely fast TTFF (Time To First Fix) at low signal level
• Supports NMEA 0183 data protocol
• Super-cohesive magnetic for mounting on the car roof or elsewhere
• Water resisted and non-slip on the bottom
• USB interface connection port
• WAAS / EGNOS Support
Performance Specifications (Data Sheet)
Chipset: SIRF Star III
Frequency: L1, 1575.42 MHz
C/A Code: 1.023 MHz chip rate
Channels: 20 channel all-in-view tracking
Sensitivity: -159 dBm
Protocol:
GPS Protocol: Default: NMEA 0183
GPS Output Data:SiRF binary >> position, velocity, altitude, status and
control; NMEA 0183 protocol.supports command: GGA, GSA, GSV, RMC, VTG, GLL (VTG and GLL are optional)
GPS transfer rate: Software command setting (Default : 4800,n,8,1 for
NMEA )
Accuracy:
Position : 5m 2D RMS WASS Enabled; 5m 2D RMS WAAS Disabled
Velocity : 0.1m/sec
Acquisition:
Hot start: 1 sec., average (with ephemeris and almanac valid)
Warm start: 38 sec., average (with almanac but not ephemeris)
Cold start: 42 sec., average (neither almanac nor ephemeris)
Reacquisition:0.1 sec. average (interruption recovery time)
Dynamics Conditions:
Acceleration Limit: Less than 4g
Altitude Limit: 18,000 meters (60,000 feet) max.
Velocity Limit: 515 meters/sec. (1,000 knots) max.
Jerk Limit: 20 m/sec**3
Physical Characteristics
Supply Power: 4.5V ~ 6.5V
Power Consumption: 80mA typical
Output Signal Level: TTL
2.08″ Diameter X 0.75″
59″ Cable
Weight: 2.2 Ounces
Protocols:
2400/4800/9600/19200/11520
NMEA (Default 4800)
Coordinates System: Default WGS-84
Connectors: USB cable
Environmental Specifications:
Operation Temperature -40C to +80C
Storage Temperature -40C to +80C
Humidity: Up to 95% non-condensing
Due to continuous product improvements, all specifications may be subject to change without notice
Detailed Images
